Results 1 to 3 of 3
Thread: Manitowoc QD0602A
Threaded View
-
12-09-2010, 03:26 AM #3
Re: Manitowoc QD0602A
Hey,
I do lots of Ice machines; in fact I did a double TXV / dryer today in a Scotsman CME506, it also had a bad water level sensor and a bad water inlet valve. She humming now!
Manitowoc is my LEAST favorite ice machine with Hoshizaki a close second.
THAT ICE THICKNESS SENSOR, on the front "drape", it has a RED wire going from IT to the circuit board. MAKE SURE those leads are clean; remember, IF that does not do it, then replace that sensor.
PLEASE let me know how it goes, but I would also call Delfield tech support on it.
I got this information from them; BUT there is a way to test the little booger. It was a hot test and a ohm test, but I can not find the notes on that machine, in fact yours may NOT have the ice thickness sensor on it,
Good luck,
From talking to lots of people; it seems as though it THAT sensor is about all that goes wrong with them.
Similar Threads
-
Manitowoc QD0602A Loco wiring
By aaluis in forum Trouble ShootingReplies: 1Last Post: 23-08-2010, 04:52 AM -
Manitowoc ice machine
By Andy AC in forum CommercialReplies: 4Last Post: 23-04-2010, 09:14 AM -
locate aftermarket compressor 4a Q600 Manitowoc ice machine
By iceman6108 in forum CommercialReplies: 0Last Post: 11-03-2010, 04:07 AM -
Manitowoc Q series Ice Machine
By JerryG in forum Trouble ShootingReplies: 8Last Post: 12-05-2009, 01:57 PM -
Manitowoc QD0602A
By stu9334@aol.com in forum Trouble ShootingReplies: 5Last Post: 18-10-2007, 04:22 AM