Results 1 to 3 of 3
Thread: Howden WRV oil connections
-
25-07-2010, 11:50 PM #1
Howden WRV oil connections
Can anyone advise on correct piping of oil connections .
Each compressor has 4 off oil connections , 2 on each side of compressor that common up connections and have usually only seen 2 used .
What conditions would require all 4 to be piped up and does ot matter if you connect them anyway?
-
26-07-2010, 11:51 AM #2
Re: Howden WRV oil connections
The four connections are to provide piping options dependant on the package configuration, connecting all four would not be detrimental, but is not required. On some tilt pad bearing compressors (designated WRVT) it is recommended to have both dicharge end connections connected to provide additional lubrication.
-
26-07-2010, 01:05 PM #3
Re: Howden WRV oil connections
Thanks Howden support .
Similar Threads
-
York YS chiller water connections left vs right hand config
By Pete S in forum CommercialReplies: 1Last Post: 17-06-2010, 06:54 PM -
Hotpoint HB8696 Fridge Freezer connections???
By Odin21100 in forum DomesticReplies: 0Last Post: 21-05-2010, 01:02 PM -
Manual Vi setting for Howden WRVi255
By desaipt2003 in forum Industrial CompressorsReplies: 13Last Post: 04-08-2009, 11:47 AM -
Howden WCV255 & WRV255 Interchangeability
By desaipt2003 in forum Industrial CompressorsReplies: 6Last Post: 09-06-2009, 02:22 AM -
Howden compressor questions
By cygbob in forum Industrial CompressorsReplies: 10Last Post: 21-03-2009, 11:40 AM