Results 1 to 8 of 8
-
05-07-2010, 07:29 PM #1
Vauxhall Opel Zafira High Side Service port Query
Hi All
Tried to hook up to an Opel Zafira today and the high side service port is not the standard service port and my connector wont engage, need to source one and would ideally like a pointer in what I am looking for, chaps keen to get this sorted so need to get this asap, is there a Vauxhall only connector?
As this is my first Vauxhall so far I don’t honestly know, any info would be appreciated.
Best Regards
-
05-07-2010, 09:08 PM #2
Re: Vauxhall Opel Zafira High Side Service port Query
may be completly wrong but i think i remember it being behind the front grill or there abouts
-
05-07-2010, 11:13 PM #3
Re: Vauxhall Opel Zafira High Side Service port Query
What is different about the high side port, I'm intrigued?
Brian - Newton Abbot, Devon, UK
Retired March 2015
-
06-07-2010, 12:01 AM #4
Re: Vauxhall Opel Zafira High Side Service port Query
it is indeed bottm left ish but my high side Coupler would not go over the port to “clip” on.
The port had a slight nut like look and not the round port I have seen so far, it seemed slightly too large for the coupler to pass over if that makes sense?
Only had a limited exposure so far to a lot of manufacturers and this is my first Vauxhall, so was checking I am not being a numpty!
-
06-07-2010, 09:03 PM #5
Re: Vauxhall Opel Zafira High Side Service port Query
me being a numpty used an old connector and its on without any problems my new one just will not connect most odd...
thanks for looking
-
06-07-2010, 10:10 PM #6
Re: Vauxhall Opel Zafira High Side Service port Query
A problem shared is a problem halved; so I'm told.
Brian - Newton Abbot, Devon, UK
Retired March 2015
-
06-07-2010, 10:46 PM #7
Re: Vauxhall Opel Zafira High Side Service port Query
[quote=Brian_UK;194114]A problem shared is a problem halved; so I'm told. [/quote
Funny I feel the same about the ex wife
-
06-07-2010, 11:05 PM #8
Re: Vauxhall Opel Zafira High Side Service port Query
If it's the old shape then it's a standard quick coupler. Not sure about the new shape but pretty sure the same thing goes.
Is it possible to undo the quick coupler bit then screw a normal 1/4" line on?Health and safety first..........unless I'm in a hurry.
Similar Threads
-
A/C Pressure problem - Low side too high
By Acrisoft in forum Air ConditioningReplies: 7Last Post: 17-09-2009, 12:14 PM -
Service Procedures For TK Scroll
By absolute-zero in forum TransportReplies: 0Last Post: 03-02-2008, 07:42 PM -
SL/SB-400 Pump Down Procedures
By absolute-zero in forum TransportReplies: 1Last Post: 29-01-2008, 09:27 PM -
High Side Pressure is ...
By SULTAN in forum Trouble ShootingReplies: 5Last Post: 14-08-2007, 12:53 PM -
Looking for a source for stainless side port distributor
By 128cyclist in forum Technical DiscussionsReplies: 1Last Post: 21-06-2007, 10:07 PM