Results 1 to 4 of 4
-
07-06-2010, 04:53 PM #1
york s7 compressor / motor alignments
Can any one tell me how to get a procedure for alignment of the motor and compressor, I think you have to do a slight misalignment for thermal growth. not sure, any info would be great
Thanks
-
07-06-2010, 04:59 PM #2
Re: york s7 compressor / motor alignments
This is a 1000 ton york screw chiller
-
07-06-2010, 05:17 PM #3
Re: york s7 compressor / motor alignments
For proceedure try-
http://www.reliabilitydirect.com/ali...0Procedure.htm
You'll have to check with the manufacturer for any required thermal growth values, otherwise align couplings, run unit to achieve operating temp then re-check alignment, compare with cold values & make adjustments if you feel necessary..Last edited by Gingerair; 07-06-2010 at 05:23 PM. Reason: Rio's dodgy knee...
-
27-07-2010, 03:38 AM #4
Re: york s7 compressor / motor alignments
i remember its capacity is 1052 ton
Similar Threads
-
York Chiller problems
By ingherrera in forum CommercialReplies: 18Last Post: 26-07-2011, 03:10 PM -
YORK ducted split
By ALONEI in forum Trouble ShootingReplies: 7Last Post: 10-07-2010, 02:18 AM -
York Screw Model YCASO330
By James K. Donell in forum Technical SpeculationsReplies: 1Last Post: 12-06-2010, 11:24 PM -
Best place to get York Chiller parts
By richard55 in forum IndustrialReplies: 1Last Post: 21-09-2009, 10:12 AM -
York Recip NH3 Compressor Info
By CIR391 in forum Industrial CompressorsReplies: 1Last Post: 05-05-2009, 11:51 AM