Results 1 to 2 of 2
  1. 06-04-2010, 09:08 AM #1
    sk4tec's Avatar
    sk4tec Guest

    Hotpoint FF200L question.



    I have this fridge freezer and have a question about it. Its a tall unit with the freezer at the bottom and the fridge at the top.

    I recently had the fridge (bottom door) seal replaced as it was coming unstuck. After that was fixed I was curious to have a look a the seal for the fridge and it appears that the rubber door seal doesn't touch the door frame in the middle of the fridge. Its a small gap.

    My question is if this is gap is be design or a fault in the door seal? I'm concerned as I chose this fridge freezer as it had better energy consumption than the Bosch I was looking at.


  2. 06-04-2010, 01:27 PM #2
    lowcool's Avatar
    lowcool
    lowcool is offline VIP Poster
    Join Date
    Feb 2008
    Location
    adelaide sth.oz
    Posts
    1,015
    Rep Power
    19

    Re: Hotpoint FF200L question.

    get em back to fix it,alot of seals require gentle heating to form to the desired state
    mmm to beer or not to beer...........lets drink breakfast
« Previous Thread | Next Thread »

Similar Threads

  1. Hotpoint FF200E Fridge Freezer Fault
    By fredalfred in forum Domestic
    Replies: 107
    Last Post: 29-12-2012, 01:26 PM
  2. FF Write Off but still under Hotpoint Parts Warranty
    By leftexit in forum Domestic
    Replies: 3
    Last Post: 22-09-2009, 04:24 PM
  3. Pretty Hard Question about calculating a vacuum.....help
    By halfcan in forum Training
    Replies: 1
    Last Post: 02-06-2009, 04:01 PM
  4. Refriferation cycle question
    By ozmecheng in forum Fundamentals
    Replies: 32
    Last Post: 26-03-2008, 10:38 PM
  5. Urgent, Kirchoff question
    By Peter_1 in forum Fundamentals
    Replies: 4
    Last Post: 20-01-2004, 03:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules