Results 1 to 2 of 2
  1. 24-02-2005, 01:19 PM #1
    Vicky's Avatar
    Vicky
    Vicky is offline rookie poster
    Join Date
    May 2003
    Location
    Lincoln UK
    Posts
    10
    Rep Power
    0

    Roll Bonded Evaporator



    I am being told by manufacturer that a roll bonded evaporator which was pressure tested by one of our engineers should not be pressure tested as it is too fragile. As I am not technically trained and work in the office can someone tell me how this should be leak tested?

    Thanks

    Vicky


  2. 24-02-2005, 01:57 PM #2
    chemi-cool's Avatar
    chemi-cool
    chemi-cool is offline Moderator Site Moderator : and general nice guy
    Join Date
    Sep 2003
    Location
    ISRAEL
    Age
    72
    Posts
    4,248
    Rep Power
    46

    Re: Roll Bonded Evaporator

    It is a bit risky for the evaporator but if you do not exceed 4 bar, it should be ok.

    Chemi
« Previous Thread | Next Thread »

Similar Threads

  1. Designing Roll Bond Evaporator
    By Munzar Ata in forum Fundamentals
    Replies: 11
    Last Post: 05-08-2010, 11:31 AM
  2. Air Source Heat Pump - temp of refrigerant leaving evaporator
    By anup in forum Fundamentals
    Replies: 3
    Last Post: 06-11-2006, 05:04 AM
  3. Evaporator Design-Air Source Heat Pump for water heating
    By anup in forum Technical Discussions
    Replies: 7
    Last Post: 20-03-2006, 02:26 PM
  4. Change evaporator
    By tralex in forum Fundamentals
    Replies: 6
    Last Post: 29-12-2005, 07:53 PM
  5. Iced Evaporator
    By Abe in forum Commercial
    Replies: 13
    Last Post: 06-11-2002, 01:34 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules