Results 1 to 7 of 7
Thread: slide valve modification
-
11-02-2010, 05:53 AM #1
slide valve modification
Does anyone have good drawings for modifying Mycom slide valves to change vi. Have 200, 250, and 320 that need to be 2.6.
-
13-02-2010, 10:10 PM #2
Re: slide valve modification
salamander ,
Mycom should be able to supply this to you no problem , especially if you buy spares off them .
Both slide valve and discharge end housing port have to be modified .
From what Vi are you converting from out of interest and why ?
-
15-02-2010, 04:13 AM #3
Re: slide valve modification
what are your running specs i got a chart in the car i could tell you what port to run, or with a bit of effort i can send the info via fax?
-
19-02-2010, 05:21 AM #4
Re: slide valve modification
I got the numbers for all but the 320. Customer is changing to thermosyphon, it's all about efficiency. So far I'm not intending to modify the discharge, but I haven't seen anything on the 320.
-
19-02-2010, 09:08 AM #5
Re: slide valve modification
Whats t/syphon got to do with Vi ?
-
20-02-2010, 06:38 AM #6
Re: slide valve modification
I'm not sure about the math, but I know we're saving $. I've recently moved from process to NH3. Enjoy the papas fritas.
-
20-02-2010, 11:08 AM #7
Re: slide valve modification
So what type of oil cooling did you have before t/syhpon ?
Similar Threads
-
Slide valve wear on Grasso screw after just 54000 Hrs
By Lodiev in forum Technical SpeculationsReplies: 11Last Post: 14-09-2009, 01:21 PM -
calibrating slide valve on rxf control pannel
By marley in forum IndustrialReplies: 5Last Post: 30-08-2009, 06:26 PM -
LEV does not open
By Yuri B. in forum Air ConditioningReplies: 7Last Post: 19-07-2009, 02:37 PM -
FRICK TDSH 233 Slide Valve and guide damaged
By 404cab in forum Industrial CompressorsReplies: 9Last Post: 30-07-2008, 11:24 PM -
Autoloading slide valve for Screw compressor
By screw_geek in forum Industrial CompressorsReplies: 32Last Post: 04-04-2008, 03:47 AM