daddyg13g

[daddyg13g]

furnace problem with a rheem criterion furnace ignites runs for a minute shuts down and re ignites runs for a minute then shuts down. Can not make temp. unless you lower stat below set point then raise it back to desired temp press hold and it will run ok. We changed stat ok. Possible circuit board problem, anyone help

[Brian_UK]

Seems a very odd place to ask about furnace problems.

[psycho]

daddy, your right ,prob a board,
Brian , or anyone any tips on removing a crankcase heater After going mad with a drill and snapping it off prob a couple off inches into the hole ? the drill bits the same size as the hole , i got 12 hrs then i'm back to site to get this heater fitted , i'm not expecting a solution to be honest i may get a bigger hammer , find som new diamond drill bit availabe locally or blow myself up wiyh a bomb,just kidding

Ineed a tool that hasent been invented yet anyone know where i can get one


A bigger hammer then :-)

[psycho]

Daddy

R u performing a reset via the stat following a lockout due to a not pilot but flame proving sensor ,i dont work on critons prob can't even spell it . is your stat a giggital proggramer or an electromechanical device. u from ny ? cool