Results 1 to 2 of 2
Thread: Frick oil leak
-
17-10-2009, 12:46 PM #1
Frick oil leak
Had an oil leak on Frick 283 "O" ring load indicator rod .
Bit of a problem as oil & ammonia was leaking but no one knew about it until to late .
Oil & ammonia had only one way to go and thats in electrical comduit which runs back to quatum panel .
Quantum panel screen destroyed as all hazy can"t red it anymore .
Disconnected conduit gland on bottom of unload cylinder cover .
Seems a suspect set up as no oil drain or anything on this cover .
I can"t be the first thats this has happened too ?
-
17-10-2009, 04:35 PM #2
Re: Frick oil leak
No you are not the first. All the conduit laden compressor packages had this potential...yours was the simplistic solution.
Many of the packages now set up such that all final connections made via jacketed cable which means the cable and terminations suffer but the PCB's usually survive.
Similar Threads
-
Mitsubishi Gas leak? PURY P250 YGMA
By marc5180 in forum Air ConditioningReplies: 82Last Post: 31-12-2010, 07:28 PM -
Leak detectors
By Temprite in forum Tools and CalculatorsReplies: 54Last Post: 18-08-2010, 04:15 PM -
USX Ultrasonic Leak Detector advice
By rick19821982 in forum Tools and CalculatorsReplies: 3Last Post: 24-06-2009, 08:43 PM -
Frick shaft seal-NH3 leak
By modvalve in forum IndustrialReplies: 16Last Post: 27-03-2009, 04:56 AM -
Evasive gas leak
By Feeze in forum Technical DiscussionsReplies: 24Last Post: 18-08-2008, 07:22 AM