Results 1 to 5 of 5
Thread: Hanbell screw
-
17-10-2009, 09:20 AM #1
Hanbell screw
Hi all
Can anybody advise if the Hanbell screw is a reliable machine, any disasters, failures etc?
Pavilion
-
17-10-2009, 10:25 AM #2
Re: Hanbell screw
Apparently they don't like long pumpdowns as it causes overheating .
Also stipulated in their litrature .
-
17-10-2009, 07:24 PM #3
Re: Hanbell screw
Hi i found handbell screws to be very reliable and easy to repair ,ie winding are easily rewoundable and tools for overhaul are standard bearing tools, the slide piston rod used to break on older models but the newer ones are fine, the best thing i like about them is they have thick gaskets which i think are better than orings in sealing
-
18-10-2009, 07:48 AM #4
Re: Hanbell screw
I think they now have more slide valve suport when unloaded , to prevent slide piston rod overstressed from vibrations .
-
09-12-2009, 08:33 PM #5
Re: Hanbell screw
hello everybody. i work with hanbell and they are very good
Similar Threads
-
VSD on screw machines
By Mike Hopkins in forum New TechnologiesReplies: 14Last Post: 20-02-2011, 12:10 AM -
Hanbell Screw Compressor Not Loading
By Denjosh in forum CommercialReplies: 6Last Post: 12-05-2010, 05:59 PM -
Compressors - screw or reciprocating?
By Josip in forum Industrial CompressorsReplies: 18Last Post: 27-01-2009, 10:36 PM -
advantage of twin screw compressor over single screw compressor
By azzah in forum New to REReplies: 7Last Post: 23-09-2008, 09:24 AM -
Mono or twin screw
By Nirmalya in forum Industrial CompressorsReplies: 43Last Post: 12-09-2006, 03:19 AM