Results 1 to 3 of 3
Thread: Mycom starting issues
-
23-09-2009, 10:59 AM #1
Mycom starting issues
We have a F42WB Mycom compressor. It was just rebuilt ( new crank,piston sleaves,pistons and valve plates etc). Since the rebuild the compressor is having a hard time restarting either after a defrost cycle or met temperature requirements. System about 18 years old. Any ideas?
-
23-09-2009, 01:13 PM #2
Re: Mycom starting issues
I would look at the unloaders. It is possible that they were not adjusted properly during reassembly.
-
23-09-2009, 03:07 PM #3
- Join Date
- Sep 2009
- Location
- Iran
- Age
- 66
- Posts
- 672
- Blog Entries
- 1
- Rep Power
- 19
Re: Mycom starting issues
1- look for unloading system .( is it 3 way solenoid valve our 2 way solenoid valve )
In 3 way during stat is off
In 2 way during start is on ( in side connection pipe with valve there is orifice it should be clean)
2 - Also check, check valve between intermediate and suction valve (working- direction )
Similar Threads
-
Mycom relief valve issue?
By Mojjee in forum IndustrialReplies: 32Last Post: 15-05-2009, 03:26 AM -
mycom 4wb unloading problem
By samlee12 in forum IndustrialReplies: 13Last Post: 19-01-2009, 10:21 PM -
Oil Loss 250 VLD Mycom Screw
By Keith1977 in forum NH3Replies: 23Last Post: 20-09-2008, 12:28 PM -
First starting off
By marc5180 in forum Legal-Business-MarketingReplies: 7Last Post: 08-10-2007, 05:51 PM -
Starting a compressor, and receiver questions.
By DaBit in forum Technical SpeculationsReplies: 9Last Post: 24-08-2002, 12:37 PM