Results 1 to 8 of 8
-
19-09-2009, 11:29 AM #1
Carrier Genesis AL2 High Pressure alarm.
Hello, I have a Carrier Genesis TM800 fridge trailer. The unit starts up o.k. but cuts out displaying the alarm code `HI PRESS`. I take this to mean high pressure. Any thoughts on how to solve this fault?
Thanks
-
09-10-2009, 07:21 PM #2
Re: Carrier Genesis AL2 High Pressure alarm.
It also could be low pressure or empty system
-
29-10-2009, 08:53 PM #3
Re: Carrier Genesis AL2 High Pressure alarm.
post in the transport section
-
29-10-2009, 09:05 PM #4
Re: Carrier Genesis AL2 High Pressure alarm.
Thread moved
-
30-10-2009, 03:38 AM #5
Re: Carrier Genesis AL2 High Pressure alarm.
If it was a low pressure issue, you would get "sys check" alarm.
If all the belts are on, you will need to hook up gauges and see what is going on.
-
31-10-2009, 12:51 AM #6
Re: Carrier Genesis AL2 High Pressure alarm.
[QUOTE=abbsnowman;165224]If it was a low pressure issue, you would get "sys check" alarm.
If all the belts are on, you will need to hook up gauges and see what is going on.[QUOTE]
Not always with the "sys check" depends how the parameters are set on the micro.
Agree with the hook up the gauges bit though
-
31-10-2009, 12:54 AM #7
Re: Carrier Genesis AL2 High Pressure alarm.
Could also be dodgy MP+ feed from the battery. Have seen that before.
But as abbs says, if you put your gauges on and run the unit check if you have hi pressure first?
-
02-11-2009, 03:58 PM #8
Re: Carrier Genesis AL2 High Pressure alarm.
The original Summit micro would not shut down or give an alarm on low suction pressure. When they first added the low suction pressure shut down the micro would show "HI PRESS". Ther are quite a few units out there like that. The newer revision micros will show the "SYS CHECK" alarm on low press. and Hi Press on High pressure. Hook some gauges up and it shouldn't be too hard to figure out which it is.
Similar Threads
-
MICROPROCESSOR DIAGNOSTICS/Differnces beteween TK/CTC
By REEFER-TEK in forum TransportReplies: 12Last Post: 27-03-2011, 04:12 AM -
discharge pressure too high
By zahar in forum Trouble ShootingReplies: 7Last Post: 16-02-2008, 08:58 PM -
High Deferential Oil Pressure Alarm
By NNNNNN in forum Trouble ShootingReplies: 27Last Post: 24-12-2007, 01:06 PM -
TK basic micro-p features and functions
By REEFER-TEK in forum TransportReplies: 0Last Post: 05-12-2007, 06:25 PM -
High Side Pressure is ...
By SULTAN in forum Trouble ShootingReplies: 5Last Post: 14-08-2007, 12:53 PM