Thanks for the feed back. I agree the "Freezer Guy" is a dead loss but he is the best available here in the 4th world and right now. He does braze well and is neat in his work just isn't tuned up to custom stuff or design... he only "fixes" them usually. That's why I was getting a bit frustrated. The two freezer units are not large. One is about 120 Liters and the other about 90 liters. The eutectic plates are built in and wrap around the whole box ( both cases) about 1/3 the way down the sides. They both have 12 individual lines from a common manifold with half going clock wise and the other half counter clockwise inside the plates. They are well spaced and well supported. The boxes are narrow and deep. Here is a list of what I was sent to work with.

2 X Danfoss BD50F compressors
2 X Danfoss 101N0500 electronics packages ( 12/24 Vdc & 220 Vac)
2 X Eliwell IC 901 thermostat / control units 12Vdc ( although the actual units say IC 961 on them)
4 X temp sensors for above
2 X Danfoss TN2 TEV
2 X Danfoss 00 orifices for above
2 X 2lb receivers with pressure relief valves and regulators
2 x Site gauges with fittings
2 X drier/filter units For 1/4 ton capacity

I didn't put all this before to avoid jamming up my notice.

Again thanks for the help it really is appreciated