Results 1 to 4 of 4
Thread: KRP4A - Daikin Split A/C
-
29-08-2009, 02:16 AM #1
KRP4A - Daikin Split A/C
Hi everyone. I was trying to commission a job that was finished over 12 months ago and found that the leads are missing from the KRP4A card that wire to P1 and P2. does anyone know where i can find some plugs to suit. I asked Daikin and they say i could be hard to supply just the leads as they come with the KRP4A kit.
-
08-11-2009, 07:36 PM #2
Re: KRP4A - Daikin Split A/C
you should be able to get them on a special request, otherwise i would go to an electronics place..or solder some cables on..
-
08-11-2009, 09:04 PM #3
Re: KRP4A - Daikin Split A/C
There was a lot of problems with KRP's messing up the workins of some systems, in perticualr im thinking back to highwalls....
... it might be that this has been done on purpose!
-
08-11-2009, 09:38 PM #4
Re: KRP4A - Daikin Split A/C
it is usually the case that something is not wired properly that usually messes up the installations...
Similar Threads
-
Daikin R410A Split System- help ??
By Testech in forum Air ConditioningReplies: 2Last Post: 23-11-2008, 08:13 PM -
Daikin R410A Split System
By Testech in forum Heat PumpsReplies: 8Last Post: 29-10-2008, 07:32 PM -
Daikin Multi Split A/C problems
By timholmes204 in forum Air ConditioningReplies: 6Last Post: 22-05-2008, 12:09 AM -
Daikin split problem (any ideas)
By airconjohn in forum Air ConditioningReplies: 14Last Post: 17-02-2008, 08:40 PM -
Daikin twin split
By Lippygit in forum Trouble ShootingReplies: 2Last Post: 28-07-2007, 06:28 PM