Results 1 to 10 of 10
Thread: carrier 30gx scpm board
-
15-08-2009, 07:28 AM #1
carrier 30gx scpm board
hi guys,
i am trying to replace a faulty compressor board scpm of 30 gx chiller.i fixed new scpm board but there is a alarm showing loss of comunication with screw compressor board 3 .does this new board have to be programed please help to fix this issue.
anish
-
19-08-2009, 05:25 PM #2
Re: carrier 30gx scpm board
hi aneesh
First u check ur connection is right.Then match the address switch (DIP Switch) with old board which is u removed and put the dip switch in correct position.
vinod
-
19-08-2009, 06:59 PM #3
Re: carrier 30gx scpm board
Try to put all your board connections in the correct way. If the new board is a direct replacement to the failure one then you should not worry about reprograming it.
-
20-08-2009, 05:01 AM #4
Re: carrier 30gx scpm board
hi there from my experience there is no need to program this card just make sure u connect it the same way as the old one including dip switches!!!!!!!
usualy it is the main board that needs programing when left with out power for a month or longer & that is when u need carriers help
-
23-08-2009, 07:13 PM #5
Re: carrier 30gx scpm board
hi guys,
i have set the dip switch same as the faulty board and the wiring connection also as before
-
24-08-2009, 04:49 PM #6
Re: carrier 30gx scpm board
hi aneesh
scpm board has 3 set dip switch.set 8 nos and MTA dip switchs.This is not a programmable board
vinod
-
27-08-2009, 09:02 AM #7
Re: carrier 30gx scpm board
hi guys
i have seen 3 dip switches in the board and have set same as faulty board no result.we tryed to contact carrier local office advice the board as been sent to programing.i dont they are fooling us..........
-
31-03-2010, 10:52 PM #8
Re: carrier 30gx scpm board
you do need to set the dip switches to the same as the old board,but the board wont ever work without the carrier software intalled by the service department or by specifying which software you want in it before it is shipped from the spares dept
-
01-04-2010, 05:13 AM #9
Re: carrier 30gx scpm board
cpm module requires no software to configure the swicht dip, place the mta according to the compressor, check the cables of communication between modules
-
19-04-2010, 07:13 PM #10
Re: carrier 30gx scpm board
i was answering the question on a phase 3 model with a grey keypad which i assure you requires software.the older models with black keypads use dip switches to set the address and compressor size but the cpm board is no longer available and has to be retro-fitted.
Similar Threads
-
MICROPROCESSOR DIAGNOSTICS/Differnces beteween TK/CTC
By REEFER-TEK in forum TransportReplies: 12Last Post: 27-03-2011, 04:12 AM -
Carrier chiller basic board problem
By noushad123 in forum Trouble ShootingReplies: 25Last Post: 17-06-2010, 06:55 AM -
carrier 30gx oil separator heaters
By Coolie in forum Trouble ShootingReplies: 6Last Post: 12-05-2010, 05:58 PM -
Carrier 30GX control issues
By whoopy-do in forum Trouble ShootingReplies: 6Last Post: 03-11-2007, 12:05 AM