Results 1 to 6 of 6
Threaded View
-
26-06-2009, 10:46 AM #1
fusible plug on absorption cooling unit
Hi, everyone, i am new here. According to CSA requirement:" 1.10.2 A system, unless constructed so it will not
burst due to expansion of the refrigerant when subjected
to abnormal outside temperatures, such as those
generated by a fire, shall be protected by one of the
following types of pressure relieving devices:
a. A safety valve having a 1/4-inch (6.4 mm)
outlet;
b. A rupture member having an outlet not less
than 1/16 inch (1.6 mm) in diameter; or
c. A fusible plug having a maximum fusing point
of 280 F (138 °C) and an outlet not less than
1/16 inch (1.6 mm) in diameter. "
We are following the C option. Consul and dometic are doing in different ways.Can anybody explain how to do this? Our questions:
1, When to weld the fusible plug into cooing unit? Before or after passivation/ painting?
2, if before passivation, will the oven temperature melt the alloy?
3, If after passivation, how to treat the pipe inside of fusible plug?
Similar Threads
-
Daikin a/c units.
By rick in forum Air ConditioningReplies: 59Last Post: 18-02-2008, 09:22 PM -
hitachi utopia g7 r404a not up to cooling
By peter1927 in forum Trouble ShootingReplies: 12Last Post: 16-01-2006, 03:19 AM -
Cooling tower evaporation, blowdown, makeup and cycles
By miltbeychok in forum IndustrialReplies: 5Last Post: 14-10-2005, 06:34 PM -
Cooling tower evaporation, blowdown, makeup and cycles
By miltbeychok in forum FundamentalsReplies: 0Last Post: 13-10-2005, 05:14 AM -
Regulation of cooling capacity
By npaisnel in forum DomesticReplies: 13Last Post: 08-02-2002, 11:22 PM