Results 1 to 3 of 3
Thread: Temperature difference
-
16-06-2009, 06:35 AM #1
Temperature difference
Hallo,
I want to connect one air cooler into a circuit ( power pack) whose evaporation temp. is -6 ( R404A). The room temperature desired is 10-12C. Normally I should mount an evaporating pressure regulator on the outlet of air cooler ( Danfoss KVP).
In order to have more capacity ( bigger delta T) on the air cooler, is it indicated to connect directly ? In this case the difference would be 10-(-6)= 19K. Sounds to be something wrong here. What is it your oppininion?
Jax
-
19-06-2009, 02:19 PM #2
Re: Temperature difference
deer sir comp rpm is 3000 and temp want 10c so what capellary size use
-
19-06-2009, 02:55 PM #3
Re: Temperature difference
I Jax,
Probably it will blockage the aircooler, even if the fans are always ON when the temperature is reached.
- What's the fin spacing?
- Has the aircooler defrost system?
- Has the aircooler a big margin of capacity?
- Is there a lot of moisture inlet at the room? Is any production of vapor (not counting with the persons who work there)?
These are some aspects that we should have in mind.To make progress is never good enough, I want to do better and better and better
Similar Threads
-
MICROPROCESSOR DIAGNOSTICS/Differnces beteween TK/CTC
By REEFER-TEK in forum TransportReplies: 12Last Post: 27-03-2011, 04:12 AM -
Superheat and Subcooling
By Chunk in forum FundamentalsReplies: 42Last Post: 15-01-2011, 01:24 AM -
LG heat pump problem
By back2space in forum Heat PumpsReplies: 132Last Post: 01-02-2009, 11:23 PM -
re ref. circuit
By shsalameh in forum FundamentalsReplies: 5Last Post: 06-08-2007, 12:59 PM -
Article in ACH&R News
By Gary in forum FundamentalsReplies: 8Last Post: 20-05-2003, 12:27 AM