Results 1 to 3 of 3
Thread: Chiller connectivity problem
-
08-05-2009, 08:00 AM #1
Chiller connectivity problem
Friends i have a problem to connect a york millinium recip. Chiller to my pc.
Any one have any idea for this!
Which software can be use to resolve this problem.
Infact! I want to monitor and control this chiller from my pc at rs485 network.
-
08-05-2009, 10:52 AM #2
Re: Chiller connectivity problem
Hi ALLAHHOOPK
Firstly what is it you require the PC to do with the controller? If its to act as a simple time clock then you can interface with relays through the remote start / stop line, if you want to control setpoints etc and use as a repeater panel where you can monitor remotely then you'll probably need a BACNET , MODBUS, EMS type interface
-
12-05-2009, 05:57 PM #3
Re: Chiller connectivity problem
Dear i don't know the software, which can be use to connect the chiller miro board. Interfacing is the second step.
Thanks with regards.
Similar Threads
-
Carrier chiller basic board problem
By noushad123 in forum Trouble ShootingReplies: 25Last Post: 17-06-2010, 06:55 AM -
Problem with Trane RTAD100 chiller.
By on4hf in forum Trouble ShootingReplies: 8Last Post: 14-10-2009, 09:01 PM -
York YK Chiller Problem
By icebox in forum Refrigeration BooksReplies: 13Last Post: 01-07-2008, 06:05 PM -
York Chiller Excessive Purges Problem
By imranmd in forum CommercialReplies: 5Last Post: 07-03-2008, 05:13 AM -
R11 Centrifugal Chiller Oil Problem
By iceman007 in forum Trouble ShootingReplies: 8Last Post: 17-02-2008, 02:14 AM