Results 51 to 56 of 56
-
11-05-2009, 10:51 PM #51
-
11-05-2009, 11:03 PM #52
Re: Few question about Mitsubishi Heavy Industrial air condition
Yep, keep the filter clean and flush the drain with clean water every few months, your installer can show how.
al
-
12-05-2009, 02:49 AM #53
Re: Few question about Mitsubishi Heavy Industrial air condition
It wont leak as the units have a drainage tray in side where any water dripping off the heat exchanger drips into the tray and drains away outside.
However if you dont keep the unit cleaned and serviced then dirt can build up and block.
If it did leak they dont leak much its not much on a wall mount.
-
12-05-2009, 09:54 AM #54
Re: Few question about Mitsubishi Heavy Industrial air condition
Is this unit is for indoor or outdoor?
Another thing I'm not sure about that, we have a terraced house - at the back of garden - my room is double glazed window and next to my window they have old fashion windows - they usually leave window open during summer -
Outdoor unit - will they make lots of noise so that can disturb them? i still wonder how loud is 47dbA?
Another thing - if i buy goods from wholesaler of the refrigeration and air-conditioning industry - do i have to purchase the goods for 15% VAT or how can i claim 5% VAT ?
-
12-05-2009, 12:40 PM #55
Re: Few question about Mitsubishi Heavy Industrial air condition
Hi guys,
Please ignore post no #54, I'm sorry to inform you guys as some urgent priority came up our finance problem, therefore we are unable to get the funds to buy air condition or pay engineer to install.
I would like to say thank you for all your supports & kindness. God bless you all
Best regards
-
12-05-2009, 02:35 PM #56
Re: Few question about Mitsubishi Heavy Industrial air condition
Is this unit is for indoor or outdoor?
Both have drainage channels that need to be connected to drain.
The outdoor units in cooling emit a low hum noise from the fan and compressor.
Nothing loud though if its very close to a window thats open you will prob not here this.
Seen your next post... good luck with if you decide to do this in the future.
REgards
Richard
Similar Threads
-
mitsubishi heavy split fault
By grovecoooling in forum Air ConditioningReplies: 7Last Post: 13-03-2011, 12:29 PM -
Mitsubishi Heavy Industries FDC2501 tech advice required
By aeaves in forum Air ConditioningReplies: 1Last Post: 20-04-2009, 08:44 AM -
Mitsubishi Heavy Industries
By Freecool in forum Air ConditioningReplies: 6Last Post: 17-08-2007, 03:20 PM -
Troubleshooting Mitsubishi Heavy VRV System
By Cofreth in forum Trouble ShootingReplies: 2Last Post: 29-08-2006, 05:41 PM -
Mitsubishi heavy industrial A/C.
By Langer in forum Air ConditioningReplies: 10Last Post: 14-08-2006, 11:31 AM