Results 1 to 3 of 3
Thread: Designing a refrigerator
-
03-04-2009, 11:52 AM #1
improving poster
- Join Date
- Jun 2007
- Location
- Canada
- Age
- 42
- Posts
- 21
- Rep Power
- 0
Designing a refrigerator
I am designing a refrigerator and i figured out where all the components are going to fit where. I got a 1/2HP compressor set and it runs on 404a.
How can i determine how much refrigerant I will need to properly run this custom made system.
Any help would be apprecaited.
-
03-04-2009, 12:05 PM #2
Moderator
Site Moderator : and general nice guy
- Join Date
- Sep 2007
- Location
- Split Croatia
- Age
- 57
- Posts
- 6,151
- Blog Entries
- 6
- Rep Power
- 36
Re: Designing a refrigerator
By trial and error, if capillary expansion device, and by subcooling and superheat, if TXV!
-
08-04-2009, 07:47 AM #3
regular poster
- Join Date
- Dec 2008
- Location
- UAE
- Age
- 42
- Posts
- 171
- Rep Power
- 16
Re: Designing a refrigerator
Dear,
Let me know the spec. of your eva+cond, then i can tell you approx. how much gas will be required.
Or let me know you ref(F/R) voulme then i can tell you approx.
Similar Threads
-
Designing Roll Bond Evaporator
By Munzar Ata in forum FundamentalsReplies: 11Last Post: 05-08-2010, 11:31 AM -
very big problem with refrigerator comp.heat up low cooling in REF portion
By jahangir.ahmad in forum Air ConditioningReplies: 6Last Post: 11-07-2008, 03:07 PM -
pressure release duration in refrigerator
By junhonguk in forum Technical SpeculationsReplies: 14Last Post: 13-01-2008, 07:06 PM -
Propane Refrigerator Conversion
By zolar1 in forum RefrigerantsReplies: 26Last Post: 04-02-2007, 03:42 AM -
How the refrigerator is less humid than outside
By Abu Bakar in forum FundamentalsReplies: 0Last Post: 19-06-2003, 03:06 AM
