Results 1 to 3 of 3
-
14-02-2009, 09:33 PM #1
RCE1 wired controller reduced function
Hello everybody,
Just finished a domestic install of a single MHI SRK35ZG-S split which is wired into an RCE1 controller via a Mitsi interface. I don't seem to have any control of the louvers and the '3DAuto' light remains on at all times on the wall mounted unit. It goes through the modes correctly and I can control the fan speed but can't get the 'Auto@ fan setting. Do the hard wired units have less functionality than the hand held remotes? (I cut jumper 2 on the interface, by the way.) Nor can I initiate the test sequence.
Is there anything (obvious or otherwise) I might have done wrong?
Thanks for any guidance.
-
15-02-2009, 05:28 PM #2
Re: RCE1 wired controller reduced function
Hi Krolroger
There are limited functions on the RCE1 remote compared to the handhelds as they cover more models and aren't unit specific hence the requirement for an adaptor.
If you contact 3D they have a list of the valid functions when using the RCE1 on an SRK.
However you should NOT have the 3D auto light permanently lit.
The test function is one of the invalid functions I believe
Brit
-
15-02-2009, 09:46 PM #3
Re: RCE1 wired controller reduced function
Thanks very much for that. Will try to extinguish 3D light.
Similar Threads
-
Carrier Transicold Container Problem
By Shamel in forum TransportReplies: 39Last Post: 23-01-2012, 11:23 PM -
Toshiba wired remote controller
By dodger in forum Air ConditioningReplies: 3Last Post: 15-01-2009, 10:50 PM -
MHI Standard Wired Controller
By back2space in forum Air ConditioningReplies: 3Last Post: 24-10-2008, 03:59 AM -
Electronic controller probes wired wrong
By Electrocoolman in forum Trouble ShootingReplies: 3Last Post: 12-11-2007, 06:39 PM -
Daikin Hard wired controller
By marc5180 in forum Air ConditioningReplies: 16Last Post: 10-11-2007, 06:43 PM