Results 1 to 3 of 3
Thread: 3 phase connections
-
19-03-2004, 03:37 PM #1
3 phase connections
try this, 6 leads, find the 3 pairs ie start and end to each phase.
now you have 3 pairs
take one lead out of each pair.
twist those 3 together
feed the other 3
if there is a reverse phase just swap one of the pairs over
and bobs your uncle
but do make sure its a 415 volt supply
and not 220 v delta supply.... cos some stuff these days are ran off a single phase inverter 240 in 220 volts 3 phase out.
regards
new userLast edited by davidler; 22-03-2004 at 02:09 PM.
-
19-03-2004, 05:18 PM #2
Re: 3 phase connections
Originally posted by davidler
try this, 6 leads, find the 3 pairs ie strt and end to each phase.
now you have 3 pairs
take one lead out of each pair.
twist those 3 together
feed the other 3
if there is a reverse phase just swap one of the pairs over
and bobs your uncle
but do make sure its a 415 volt supply
and not 220 v delta supply.... cos some stuff these days are ran of a single phase inverter 240 in 220 volts 3 phase out.
regards
new user
-
22-03-2004, 02:11 PM #3
answer
sorry peter, i am getting used to the way the forum works.
it was supposed to be an answer
Similar Threads
-
Single phase contactor
By Andy T in forum CommercialReplies: 9Last Post: 23-10-2006, 01:45 PM -
Phase Failure Protection
By Abe in forum ElectricalReplies: 11Last Post: 08-11-2005, 09:23 PM -
Heater/cooler split system A/C electrical connections help pls!
By JamesQB in forum Air ConditioningReplies: 5Last Post: 22-06-2005, 07:41 PM -
Phase Loss Detection
By Latte in forum New TechnologiesReplies: 37Last Post: 03-01-2005, 10:01 PM