Copper Pipe Sizing Tool.

[Testech]

At my college, I once saw a plastic pipe sizing tool.

It was quite small credit card size and had the cut outs for 1/4 to 3/8,1/2,5/8 and 3/4 on it.

For quick sizing, does anyone know where I can get one please ?.

[BritCit_Juve]

Contact your local HRP they should have something similar
Brit

[Testech]

Thanks mate !!

[BritCit_Juve]

no problem
Brit

[chillyblue]

Climate center/NRS sell them

[nguyenloc178]

i hope you sent to me it. thank you very much.

[icecube51]

why don't you make it yourself? take a piece of pipe,make it hot and melt it in a plastic plate. do so for every common pipe desire. after a few months throw it away because you now by then all the pipes by head. LOL

Ice

[refmech]

icecube51 hit the nail on the head. use an old credit card or one of thoughs fakes that come in the mail.if you fit pipe at all, you'll know them by touch in just a short while!

[Nerijus]

Hello, I wanted to ask does anybody know any software or literature for copper tubes calculations (velocity, presure drop, pipe dimensioning etc.) on what criterion I shoud tend my attention and what is doesnt matter and so on. If someone have any ideas I would be greatful if you could post some of them. I think for others it is usefull too.

[icecube51]

Hey Nike123, this is something for you...

give the guy something usefull so he can later on ask serious questions on behave of his calculated computer outcomes. (hihihi)

Ice

[nike123]

Hey Nike123, this is something for you...

give the guy something usefull so he can later on ask serious questions on behave of his calculated computer outcomes. (hihihi)

Ice

Ok Ice I will, there it is :
Pipesizer
CoolPack
Some books on piping
(books download is password protected, for download send to me personal message)

Torrent for Ashrae handbooks (2005-2008 4 CDs) (worked for me 2 month ago)

I think that should be sufficient for start (and later).

[imci]

I found this related site for copper, copper.org/resources/homepage.html
I don't know if they have "Copper Pipe Sizing Tool" but you can request a CD and/or Website Updates for free
Yes,free.All infomation from their site

[shinglai]

you can find it thru google.

[Nerijus]

Thank you for advices, I know that my question maybe was strange for you But I am just a fancier of heat pumps, and trying to make a heat pump for my house, by my self, I hope I will make it So, I have choosen a compressor, and a heat exchangers. Today my attention is based on piping. Another interesting thing that interesting me is connecting a heat exchangers with compressor.
1) What is better at discharge line , to make a loop like spring, or a simple line with straight tubes and elbows?
Is it any difference if my loop goes from comressor down then up, or up then straight to cond?
2) At suction line (at connection with compressor) do I have to put an elbow to lift a little bit pipe(or can I connect it without lifting), than down and then again up to evap? I haven't yet decided about reciver, but I will use solenoid valve,I think. Thank you

[monkeycit]

I found one on Ebay. The Original Copperciser. Excellent copper sizer tool.