The logic board is ok. what you need to know is, is this a new unit to the place it is being worked on? If you take the front panel off below the drip tray you will find a power box. Take off the cover. You will see a contactor and a power board. The ribbion from the logic board (viscocity setting) On this power board you will find some jumpers. There will be a row of about 4 or 5. The jump pin might be on the first one just move it down to the next set of jumpers. Turn your viscocity to 11:00 and start the machine again. You are adding more amps to the motor when you do this.