Results 1 to 2 of 2
-
10-07-2008, 05:28 AM #1
Support for the wall panels - cold store with no locks
Typically for the cold store wall panels with no locks - Continuous line- wall panel supports are necessary. We too have been providing the same. But I was looking for technical explanation on this. What should be the height of the wall panels where in this becomes necessary? What distances on height reference? All manufacturers have their own methodology & calculations on this & obviously that is confusing as usual.
-
10-07-2008, 09:06 AM #2
Re: Support for the wall panels - cold store with no locks
One file is attached with the issue being highlighted. THe phase One cold store if provided with the wall panel supports, the second phase installation is problematic.
Similar Threads
-
Construction of new Cold Store
By lalthomas in forum System OptimizationReplies: 23Last Post: 19-04-2009, 02:01 AM -
Heat load dye to Reach truck in cold store
By smpsmp45 in forum NH3Replies: 15Last Post: 17-06-2008, 11:07 PM -
Expansion Joints in the cold store floor
By smpsmp45 in forum NH3Replies: 2Last Post: 17-05-2008, 07:47 AM -
Cold room panels
By LLCooLJ in forum CommercialReplies: 6Last Post: 07-04-2008, 04:18 PM -
Large cold store installations - methods/ tools
By smpsmp45 in forum NH3Replies: 0Last Post: 07-12-2007, 04:50 AM