Results 1 to 2 of 2
-
07-07-2008, 09:48 PM #1
Sanyo SPW XR254 remote start/stop
Folks
Does any one know how to wire in the optional remote start/stop wiring loom on these units? connects to T10 on indoor board i think? tech manual says refer to remote control section.......which doesn't say much on the topic!!
Thanks
al
-
31-01-2009, 02:06 AM #2
Re: Sanyo SPW XR254 remote start/stop
Hi al
I take it u actually have a T10 kit.
If so first and most important snip JP001 on the indoor pcb.
Then simply switch the red and yellow wires on the T10 to operate on off.
T
T10
Similar Threads
-
DAIKIN VRV Remote controller
By 2007eng in forum Air ConditioningReplies: 15Last Post: 19-07-2008, 07:04 PM -
fault on a sanyo unit
By marc5180 in forum Air ConditioningReplies: 7Last Post: 18-08-2007, 11:04 PM -
Check your remote.
By Temprite in forum Air ConditioningReplies: 11Last Post: 26-05-2006, 08:21 AM -
Remote condenser
By Rfcont in forum Technical DiscussionsReplies: 7Last Post: 06-12-2005, 12:44 PM -
Remote Control problem
By botrous in forum Air ConditioningReplies: 2Last Post: 12-10-2005, 05:36 PM