Results 1 to 5 of 5
Thread: Single screw compressors
-
28-06-2008, 01:53 AM #1
Single screw compressors
Can anyone explain the basics of how a single screw compressor works. I did some research on the net and found a basic run down but just would like another explanantion. Cheers chris.
-
28-06-2008, 02:21 AM #2
Re: Single screw compressors
The Vilter site should have the information you are looking for.
Ken
-
28-06-2008, 04:49 AM #3
Re: Single screw compressors
There is a nice explanation of this on the Vilter site.
http://www.vilter.com/pdf/VSS_final.pdf
Look at the last page specifically.
The brochure shows the compression and capacity & Vi control in pictures along with a written description. After you read that, if you have any questions just post it in this thread.If all else fails, ask for help.
-
14-07-2008, 01:38 PM #4
Re: Single screw compressors
Hi,
Does anybody know where could i find single Screw Compressor Design Standards , manual or handbook.
I have a new plan to design this type but need technical details and Standards to complete my project.
thanksLast edited by Jahangir; 14-07-2008 at 01:42 PM.
-
05-11-2008, 09:27 AM #5
Re: Single screw compressors
You cant design a new type of single screw because even halls (mc quay) and vilter need their rotors cut by a special machine, which we rent from the man with the patent. He didn't patent the stars or the rotor design but he did patent the machine for cutting them so you need to pay him to use the machine.
Similar Threads
-
Single screw compressor
By dvtruc in forum Industrial CompressorsReplies: 56Last Post: 28-01-2010, 03:40 PM -
Compressors - screw or reciprocating?
By Josip in forum Industrial CompressorsReplies: 18Last Post: 27-01-2009, 10:36 PM -
advantage of twin screw compressor over single screw compressor
By azzah in forum New to REReplies: 7Last Post: 23-09-2008, 09:24 AM -
do u have any data on comparison of single screw and twin screw?
By vuputuri in forum Technical SpeculationsReplies: 5Last Post: 22-02-2008, 03:52 PM -
reciprocating compressors vs screw, for NH3
By lraja in forum IndustrialReplies: 15Last Post: 04-03-2007, 02:30 AM