Results 1 to 5 of 5
Thread: york screw start up
-
29-02-2008, 12:42 PM #1
york screw start up
hi guys, first time on forums hello to you all, ive just been handed a contract to check and start up york screw chilled water plant. on a navy boat. this systems are charged and have already been commisioned. but this was three years ago. and they havnt run since. ive done alot on recips but not much on screws. any advice to prestart up checks other than oil heaters. valve positions ect. typicaly there is very little in the way of an OM maunal on board
-
01-03-2008, 08:38 PM #2
Re: york screw start up
Hi Frostybritt.
If its already been commissioned you should`nt really have any problems if no-ones touched it since.
All i would suggest is that after running it up give it a good leak test just in case any seals have dried out.
good luck.
Chunk.
-
03-03-2008, 09:46 PM #3
-
06-03-2008, 08:59 PM #4
Re: york screw start up
Hi Frostybritt
I've worked on alot of york navy kit over the years.
Can you tell me more about the unit or vessel it is on.
Has it been run before or is it new???
-
11-03-2008, 12:08 AM #5
Re: york screw start up
I would suggest getting a oil sample and have it checked .
Similar Threads
-
York Millenium Screw Chiller
By iceman007 in forum Industrial CompressorsReplies: 26Last Post: 15-01-2011, 11:56 PM -
York Screw Oil Problem
By tomt in forum Technical DiscussionsReplies: 10Last Post: 02-12-2009, 02:48 PM -
york screw trouble
By sahidian in forum Trouble ShootingReplies: 9Last Post: 10-12-2007, 10:31 AM -
York Screw Chiller How low will it go?????
By bruceboldy in forum Industrial CompressorsReplies: 11Last Post: 10-08-2007, 10:29 PM -
York Open Drive Screw Chiller
By Cofreth in forum Air ConditioningReplies: 4Last Post: 24-10-2005, 02:17 PM