Daikin VRV II Intermittent E3 fault
Hello chaps,
I have been working on a reyq16mw1b r410a system today, which another company have already worked on and left in a abit of a state, they replaced inverter pcb and inverter compressor.
It had a leak which I repaired and recharged correctly.
I found EEVs (3 altogether) connected incorrectly which I have put back, I then checked all valve operations with a magnet and solnoid resistances and operation, all ok.
There are 2 X large green solnoid coils, 1 discharge gas and 1 suction gas, which when operation in heating is preformed sometimes the discharge gas solnoid energises and sometimes doesn't not, when it does not it goes out on HP, I have checked voltage from the board and it is not trying to power the solnoid, does anyone know what tells this valve to open or is it just when it's in heating.
I have also tried the tap the relay on the top trick... No luck
Next the sub 4 way valve solnoid does also not energise at all therefore always sending hot gas to sub coil, again no power out from the board to energise coil at what point should this coil energise.
after telling Daikin all this they are saying fault with main pcb, which at this time I agree.
To prove system actually runs, I ran full heating (when discharge gas solnoid decides to energise) and put a magnet on the sub 4 way valve, which was all ok.
I then ran full cooling which was also ok.
Anyone think differently to main Pcb?
I appreciate any feedback.
Thanks
Glenn
Re: Daikin VRV II Intermittent E3 fault
E3 error code for Daikin VRV2 is a sign for a tripped high pressure,
Re: Daikin VRV II Intermittent E3 fault
Quote:
Originally Posted by
Glennprice
Hello chaps,
I have been working on a reyq16mw1b r410a system today, which another company have already worked on and left in a abit of a state, they replaced inverter pcb and inverter compressor.
It had a leak which I repaired and recharged correctly.
I found EEVs (3 altogether) connected incorrectly which I have put back, I then checked all valve operations with a magnet and solnoid resistances and operation, all ok.
There are 2 X large green solnoid coils, 1 discharge gas and 1 suction gas, which when operation in heating is preformed sometimes the discharge gas solnoid energises and sometimes doesn't not, when it does not it goes out on HP, I have checked voltage from the board and it is not trying to power the solnoid, does anyone know what tells this valve to open or is it just when it's in heating.
I have also tried the tap the relay on the top trick... No luck
Next the sub 4 way valve solnoid does also not energise at all therefore always sending hot gas to sub coil, again no power out from the board to energise coil at what point should this coil energise.
after telling Daikin all this they are saying fault with main pcb, which at this time I agree.
To prove system actually runs, I ran full heating (when discharge gas solnoid decides to energise) and put a magnet on the sub 4 way valve, which was all ok.
I then ran full cooling which was also ok.
Anyone think differently to main Pcb?
I appreciate any feedback.
Thanks
Glenn
Sounds like outdoor PCB, the sub 4-way valve won't energise straight away in heating mode, it tends to operate with just the main HEX valve and Y5S to begin with (soft start) and then around 5-10 minutes it would energise the sub HEX 4 way valve, I've had a couple of VRV II's that have had this issue with the relay on main PCB for Y5S, also, if expansion valves have been installed incorrect plugs or heads on wrong valve body this will cause no end of trouble, hopefully it hasn't been like this to long other wise i see another compressor failure
