Fan blade puller UK

Hello everyone,

i was wondering if anyone could possibly point me in the right direction on where to get a fan blade remover tool in the UK.

i found plenty in USA with ridiculous postage costs i cant seem to find anything to remove fan blades in the UK.

Any names of such tools here would be appreciated.

Thanks

Rik

Try searching/Googling for "pulley puller", sold by just about everyone.

What type of fan is it,is it on the condenser or evaporator

Quote:

---

Originally Posted by cadwaladr

What type of fan is it,is it on the condenser or evaporator

---

was just an in general question mate, usually with the condenser motors though.

Thanks FaultCode i will try pulley puller instead of fan blade remover, thank you

Rik

Normally the motors are scrapped so I take the motor off cut through the shaft dose it in wd then drive it out with a punch on a vice or over a deep reach socket works everything for me.

Quote:

---

Originally Posted by cadwaladr

Normally the motors are scrapped so I take the motor off cut through the shaft dose it in wd then drive it out with a punch on a vice or over a deep reach socket works everything for me.

---

yeah i know what you mean but ive been on a few sites where we've reused the fan so cutting it off the shaft and hammering it out is not always possible on site, i saw some vids on youtube where people used a fan blade remover and i thought it looked alot easier, but when i searched it all i got was american tools but after doing what FaultCode said i found loads of them.

Thanks for both your help and advice though

Rik

.

https://www.machinemart.co.uk/p/clar...iABEgKW9PD_BwE

Machine Mart £12

Rob

.

Quote:

---

Originally Posted by Rob White

.

https://www.machinemart.co.uk/p/clar...iABEgKW9PD_BwE

Machine Mart £12

Rob

.

---

Thanks Rob this is the ones i was looking at

Thanks for everyones help much appreciated

Rik

Just be very careful if they have plastic hubs.

Lots of wd40 and a fair few prayers to your god.

Quote:

---

Originally Posted by FaultCode

Just be very careful if they have plastic hubs.

Lots of wd40 and a fair few prayers to your god.

---

Lol thanks for the advice i will bear that in mind.

Rik

I got one on ebay, just had to pay the shipping and tax from the USA, had it for seven years or so so have forgotten what it cost but still find it useful.

https://www.youtube.com/watch?v=Gy6MmNbw-2c

Quote:

---

Originally Posted by monkey spanners

I got one on ebay, just had to pay the shipping and tax from the USA, had it for seven years or so so have forgotten what it cost but still find it useful.

https://www.youtube.com/watch?v=Gy6MmNbw-2c

---

Ah yeah i have seen that one on ebay, wasnt sure if it was any good?

Thanks for the link ive already seen that i been subbed to you for a while lol

Rik