Removing one SFA15 From a DSV1 Dual manifold. (Danfos)

Hi Guys.
Can anyone advise as to the actual male thread size on the bottom of a Danfoss SFA15 to enable that port on the DSV1 dual manifold to be used to Push pull the Ammonia from a Sabroe Pac system.
Basically I need to identify the Port thread size to make up an adaptor.
Which in turn can be connected to, to facilitate the system being emptied of Ammonia.
My guess is 1" BSG. /BSP.
Can anyone clarify?
Thanks.
Grizzly

3/4" inlet and 1" outlet BSP according to their spec sheet.

http://products.danfoss.co.uk/produc...e-dependent/#/
Check under Documents.

That was quick Brian.
Impressive.
Thanks.
Grizzly