I have a yellow jacket mantooth and I this will be a stupid question but high temp pipe clamp, where dose it go on the discharge of the compressor or the liquid line.
Printable View
I have a yellow jacket mantooth and I this will be a stupid question but high temp pipe clamp, where dose it go on the discharge of the compressor or the liquid line.
It all depends on what you want to measure.
- If its on the discharge you will get the discharge superheat.
- If it is on the liquid line you will get the sub cooling.
I believe the default for the YJ app is sub cooling, so if that is what you want to see then liquid line it is.
:cool:
Ok thanks, I was looking at the testo smart probes as they are all wireless
Quote:
Originally Posted by Shussey1
???Quote:
Originally Posted by Shussey1
However, same principle applies...
:cool:
I find the interconnecting cable between the two pressure sensor too short and some times hard to fit