});


  • Google ..

  • Google Content

  • RE_Calendar

    March   2019
    Su Mo Tu We Th Fr Sa
    1 2
    3 4 5 6 7 8 9
    10 11 12 13 14 15 16
    17 18 19 20 21 22 23
    24 25 26 27 28 29 30
    31
  • ? about hydrocarbon gas

    i am thinking about starting to learning a bit about hydrocarbon gases to save money. can any one tell me what the difference between r290a and lpg is . can any one tell me why u cant just use pure lpg in a fridge all u would need is a pt chart for it. does lpg have more moister in it
    because from what i can work out it seems to work fine we tried it in a domestic fridge and ran fine for 4 years
    This article was originally published in forum thread: ? about hydrocarbon gas started by iceberg1988 View original post
    Comments 3 Comments
    1. chillerman2006's Avatar
      chillerman2006 -
      R290 is a CLEAN refrigerant

      lpg ect is dirty, moisture and non condensables and foreign bodies

      also regrigerant grade hydrocarbons are stenchless/no smell

      as the stenching agent is absorbed by drier cores

      would say you got lucky with your domestic

      R's chillerman
    1. chillerman2006's Avatar
      chillerman2006 -
      waste of thread

      have replied to your article

      R's chillerman
    1. chillerman2006's Avatar
      chillerman2006 -
      have now found you have had all the answers here

      http://www.refrigeration-engineer.co...ydrocarbon-gas

      and these dont change by reposting the same question

      thread should be deleted really

      R's chillerman
  • Recent Forum Posts

    al

    Re: mitsubishi electric outputs and alarm

    Thank you Narkom

    al 25-03-2019, 11:22 PM Go to last post
    narkom

    Re: mitsubishi electric outputs and alarm

    CN51 connector is for Fault status (3-4 contacts) and Operation status (3-5 contacts).The output voltage is 12VDC.
    The red and brown wires are

    narkom 25-03-2019, 04:32 PM Go to last post
    al

    Re: mitsubishi electric outputs and alarm

    Thanks Narkom, the 5 wire has a different set up though:

    https://www.mitsubishi-les.info/data...C_SA88HA_E.pdf

    al 24-03-2019, 02:32 PM Go to last post
    narkom

    Re: mitsubishi electric outputs and alarm

    No, it is not a pulse signal. SW1 is for remote control block and SW2 is for ON/OFF

    narkom 23-03-2019, 08:57 AM Go to last post
    al

    Re: mitsubishi electric outputs and alarm

    Thank you Hyper!

    For the remote on/off, is it a pulsed signal ie one pulse on, further pulse off?

    Al

    al 22-03-2019, 01:41 PM Go to last post