• Google ..

  • Google Content

  • RE_Calendar

    March   2018
    Su Mo Tu We Th Fr Sa
    1 2 3
    4 5 6 7 8 9 10
    11 12 13 14 15 16 17
    18 19 20 21 22 23 24
    25 26 27 28 29 30 31
  • ? about hydrocarbon gas

    i am thinking about starting to learning a bit about hydrocarbon gases to save money. can any one tell me what the difference between r290a and lpg is . can any one tell me why u cant just use pure lpg in a fridge all u would need is a pt chart for it. does lpg have more moister in it
    because from what i can work out it seems to work fine we tried it in a domestic fridge and ran fine for 4 years
    This article was originally published in forum thread: ? about hydrocarbon gas started by iceberg1988 View original post
    Comments 3 Comments
    1. chillerman2006's Avatar
      chillerman2006 -
      R290 is a CLEAN refrigerant

      lpg ect is dirty, moisture and non condensables and foreign bodies

      also regrigerant grade hydrocarbons are stenchless/no smell

      as the stenching agent is absorbed by drier cores

      would say you got lucky with your domestic

      R's chillerman
    1. chillerman2006's Avatar
      chillerman2006 -
      waste of thread

      have replied to your article

      R's chillerman
    1. chillerman2006's Avatar
      chillerman2006 -
      have now found you have had all the answers here


      and these dont change by reposting the same question

      thread should be deleted really

      R's chillerman
  • Recent Forum Posts


    Re: York YCCH193L Manual

    Thanks Paul.

    scorpx 21-03-2018, 02:45 PM Go to last post

    Re: Beverage Aire E Series Resurrection

    R134a is known to block capillaries (oil floc)

    frank 21-03-2018, 01:35 PM Go to last post

    Re: Suction valve position when set point is reached ?

    Designed in Australia and built in glasgow by Howden I think, quite nice skids. There's a commissioning engineer from Howden here dealing with the mechanical

    Tycho 21-03-2018, 12:07 PM Go to last post

    Re: Suction valve position when set point is reached ?

    to some degree.

    if the valve stays open on reached set point, the compressor really wouldn't work any more than it should because the room

    Tycho 21-03-2018, 12:04 PM Go to last post

    Sanyo multi

    Have a Sanyo multi with 3 indoor units works fine on heating for a few hours then then the 3 indoors stop heating and start flashing on indoor units check

    eurocooling 21-03-2018, 08:07 AM Go to last post