PDA

View Full Version : testing



rossaim
09-10-2007, 05:38 PM
hi guys
is there a sure way to diagnose a ptc start devise fault or compressor dont want to waste time ordering ptc start device only to find compressor faulty windings in compressor check out ok


thanks

BigJon3475
09-10-2007, 05:45 PM
Change it out. I hate Ptc devises. Try a start assist with potential relay like the K-01. Some of the older ones over here are just useless and go out very often. Does it resemble something like this?

http://i68.photobucket.com/albums/i25/BigJon3475/DSCF0400.jpg

Brian_UK
10-10-2007, 12:40 AM
Aaah, complete with natural cobwebs, just like ours :)

BigJon3475
10-10-2007, 04:38 AM
Aaah, complete with natural cobwebs, just like ours :)


Ohhh you wanted more pictures :D....I cleaned up afterwards....


this is a 21 year old Bryant heat pump

http://i68.photobucket.com/albums/i25/BigJon3475/DSCF0401.jpg
http://i68.photobucket.com/albums/i25/BigJon3475/DSCF0402.jpg

http://i68.photobucket.com/albums/i25/BigJon3475/DSCF0404.jpg

BigJon3475
10-10-2007, 04:38 AM
Notice the run cap attached to the dual run cap......:rolleyes: