PDA

View Full Version : Stal Electronic 700



Gerben
03-09-2007, 01:08 PM
Hi there,

does anyone have the lay-out or electric scheme?
I have 4 off, mounted on Stal screw compressor units to be rebuilded, but like to know if itis wired okay for testing.

Tnkx.

404cab
03-09-2007, 06:48 PM
Hello,

There is no standard scheme for Stalectronic 700, because the application can vary from provision plant units to AC or special applications.


You have to power up the Unit, go to the paramters list to enter all your datas ( Refrigerant, compressor type, etc...), then you have to set setpoint, alarms and so on.
but first you can power up , and go at the bottom of the menu and see what version software it is.

evapcoil
06-09-2007, 04:12 PM
Hi
For which application are used these compressors? I have few diagrams that You can use as a generic guide line.... And also few parameters list....
Ciao

jach67
19-05-2009, 12:45 AM
hi
I have r22 s-73 stal compressor ,whit Stal Electronic 700 ,unit fail on stopping pump
why?
in manual position is ok, when chance to auto fail,all pressure and temperature ok

Gerben
20-05-2009, 09:20 PM
Hi Jach, on the S-73 the oil pump is directly on the compressor shaft, is that right? Or is it an electronic failure?

Gerben

jach67
21-05-2009, 04:57 AM
I have help from stal,now the unit work ok,

thank gerben

coldflow
22-08-2009, 02:00 PM
Hi all!
I have a Stalectronic 700 Electronic control system for SV 10 Compressor Unit. I want use external capacity control compressor via an analog input (AI8) and a digital input (DI4) in remote operating mode, but not working. Please help me setup in Stalectronic 700. Thanks.

Mythos
07-10-2010, 06:33 AM
Hi all!
I have a Stalectronic 700 Electronic control system for SV 10 Compressor Unit. I want use external capacity control compressor via an analog input (AI8) and a digital input (DI4) in remote operating mode, but not working. Please help me setup in Stalectronic 700. Thanks.

I have the same problem. Anyone know how to get this to work?