Andy AC
26-08-2007, 01:26 PM
Hello guys, I've got a couple of porkka cold rooms to recharge, one fridge on r12, one freezer on r502. For some bizarre reason both of the monoblocs were degassed when the cold rooms were dismantled.:(
The problem is that the cold rooms are still in their dismantled state for shipping so I won't be able to run them down to temp and do a full check on them when they are running
I'm going to put R408a in the freezer and R409a in the fridge, can I put the same amount of gas in as on the data plates or would I need slightly more or less?
The other problem I have just been told about is that the bloke I am doing it for has sold them both as fridges:(, he didn't know that one was a freezer. Apart from adjusting the eliwell control and compressor life being compromised is there anything else that I would need to do to it?
The problem is that the cold rooms are still in their dismantled state for shipping so I won't be able to run them down to temp and do a full check on them when they are running
I'm going to put R408a in the freezer and R409a in the fridge, can I put the same amount of gas in as on the data plates or would I need slightly more or less?
The other problem I have just been told about is that the bloke I am doing it for has sold them both as fridges:(, he didn't know that one was a freezer. Apart from adjusting the eliwell control and compressor life being compromised is there anything else that I would need to do to it?