cypher_171
22-08-2007, 11:52 PM
Hello all,
I have a R410a split system heat pump that requires a full recharge, the service valve is on the LP Vapor Side. I know that R410a has to be charged in its liquid state to maintain the blend but im cautious of possible damage to the compressor, I intend to add refrigerant slowly throttling the valve to vaporise the liquid in the lines. I dont have to hand an atomiser/safety charger, can anyone who has had experience with these systems share there methods also the system charge is 1.5Kg is there a recommended point when i should envoke the compressor?
Your help is greatly appreciated! :)
I have a R410a split system heat pump that requires a full recharge, the service valve is on the LP Vapor Side. I know that R410a has to be charged in its liquid state to maintain the blend but im cautious of possible damage to the compressor, I intend to add refrigerant slowly throttling the valve to vaporise the liquid in the lines. I dont have to hand an atomiser/safety charger, can anyone who has had experience with these systems share there methods also the system charge is 1.5Kg is there a recommended point when i should envoke the compressor?
Your help is greatly appreciated! :)