suny
14-08-2007, 06:04 PM
Hi Everybody & thank you Jon
The following is the extract from the DuPont site with regard to the R 507.
“DuPont R-507 will maintain a very consistent composition if leakage occurs in a refrigeration system, which means that operating performance, will remain consistent following leakage/recharge cycles. As with all mixtures, we recommend that the liquid phase be removed from the storage cylinder to minimize composition changes when charging. DuPont R-507 should not be mixed with any other refrigerant when charging, recycling, recovering or reclaiming”.
I have practical experience on a leaking R 404a system. After detecting the leak and repairing it, I could not get the original performance after topping up with R 404a. The room temperature went up by 20 deg C. As this was my first R 404a system and on the instructions from the compressor manufacturer I fully evacuated the balance refrigerant and charged with fresh R 404a liquid, and immediately the performance came back to normal and working at Te -35 deg C.
As such I want to change all my equipments to R507. Please let me know about you practical experience on R507.
Suny
The following is the extract from the DuPont site with regard to the R 507.
“DuPont R-507 will maintain a very consistent composition if leakage occurs in a refrigeration system, which means that operating performance, will remain consistent following leakage/recharge cycles. As with all mixtures, we recommend that the liquid phase be removed from the storage cylinder to minimize composition changes when charging. DuPont R-507 should not be mixed with any other refrigerant when charging, recycling, recovering or reclaiming”.
I have practical experience on a leaking R 404a system. After detecting the leak and repairing it, I could not get the original performance after topping up with R 404a. The room temperature went up by 20 deg C. As this was my first R 404a system and on the instructions from the compressor manufacturer I fully evacuated the balance refrigerant and charged with fresh R 404a liquid, and immediately the performance came back to normal and working at Te -35 deg C.
As such I want to change all my equipments to R507. Please let me know about you practical experience on R507.
Suny