PDA

View Full Version : Changing a stat







jamboice
11-09-2006, 01:58 PM
Hi Folks
trying to change a stat in a Schreiber apm 6235 SX fridge. Will a Danfos No3 do the job or will there be a specific stat( who makes these fridges?).heers in advance for any sugestions.

Regards

Jamboice

davej
11-09-2006, 07:28 PM
Hi jamboice,

not sure who makes the fridges but you may be better to use a ranco vxo stat. it has a lowest cut out temp of -14, and the vt9 and the danfoss no 3 go down to -26 . sometimes those stats cause the system to run on too much and ice up. if the stat sensor is fixed to the front of the plastic liner i personally would go for the vxo.
good luck

jamboice
12-09-2006, 05:09 PM
davej
cheers 4 that trying a No3 will see how it goes!

regards
jamboice