started to make an evap for my chiller

[The MG Pony]

http://www.xtremesystems.org/forums/showthread.php?t=106780

So what you think so far, I'm making an SLHX directly on the cell to keep it highely compact, once don and pressure tested I'll finnish sealing the PVC shell and then insulate it with expanding foam, and a temp senore will be intergrated into the shell

[slingblade]

Thats nice bud, but what is it that it does? it just looks like a pointless piece of refrigerated drainpipe to me.

[The MG Pony]

lol. thats because I haven't built in the fluid carrying system yet; it is a chiller cell, that should handle a good amount. I'm setting it so the water rotates inside all around the evap surface.

[Brian]

Do you mean an evaporator?

[The MG Pony]

ya just abbreviated to evap.

[Rob S]

You'd end up with better heat transfer if you put another pvc tube inside the coil. Top view would be donut shaped. Brine would only flow between the two pvc tubes.

[The MG Pony]

I'm seting it to have spiral flow internaly and thats basicly what I'm doing, haven't started that phase yet, just finnished the refrigeration plant :D and it got lots of frost :) fast hehe.

[The MG Pony]

http://www.ocforums.com/attachment.php?attachmentid=51680&d=1153424554

So what you guys think, looking Ok? I'll post technicle details when it is more finnished.

[The MG Pony]

And as to the sewer pipe, here is the full story on that!

http://www.ocforums.com/attachment.php?attachmentid=51744&d=1153597556

There is going to be a second barb put in when I get to a place that has them on this damned coast, and that is a stainless steel thermister 6K at 21C and a 714 Op amp signal conditioner.

I'll be using a DeltaT for temp control system to lock it at -3.3Evap.