PDA

View Full Version : Daikin ducted indoor units sweating back







eurocooling
31-08-2017, 01:14 PM
We have a client and his two indoor units are sweating back the outdoor unit is in his garage and the heat his going nowhere the temp in there is 52 degrees would this cause the indoor units to start sweating ? The trouble is there is no where to extract the hot air

FaultCode
31-08-2017, 05:47 PM
His garage has walls so there is somewhere to get rid of the heat.

52C is is way above the design operating conditions I'm sure.

eurocooling
01-09-2017, 06:34 AM
His garage has walls so there is somewhere to get rid of the heat.

52C is is way above the design operating conditions I'm sure.

There is nowhere to take the heat as both sides are garage and the front of garage goes into underground drive

Slim R410a
05-09-2017, 05:08 PM
There is nowhere to take the heat as both sides are garage and the front of garage goes into underground drive

Have you got any pictures? What is behind the rear garage wall?

FaultCode
05-09-2017, 08:18 PM
Vent to the underground drive.

malik55
06-09-2017, 01:19 AM
You have to dump internal heat in place where the refrigerant can turns back in liquid form, otherwise system will not work properly, As mentioned by Mr. Brian arrange to vent it at other level, if possible try to fix a high speed extract fan to remove air from the area.

eurocooling
06-09-2017, 07:13 AM
Have you got any pictures? What is behind the rear garage wall?

This is underground garage so it impossible to vent the air

eurocooling
06-09-2017, 07:15 AM
The underground drive is like another sealed area

niceman
06-09-2017, 01:15 PM
Is it possible to convert to a water cooled condeser, heat exchanger? No way will it work if you cannot get rid of the heat from the refrigerant, best of luck to you.

eurocooling
06-09-2017, 07:27 PM
Is it possible to convert to a water cooled condeser, heat exchanger? No way will it work if you cannot get rid of the heat from the refrigerant, best of luck to you.

You are correct this was design by a Portugusse builder and work crap

malik55
06-09-2017, 11:09 PM
Is it possible to upload the building drawing and area snapshoots with units marked on it, may be there a way.

eurocooling
07-09-2017, 08:00 AM
Is it possible to upload the building drawing and area snapshoots with units marked on it, may be there a way.


I see see what I can do