PDA

View Full Version : Sabroe CMO28 mk2 comp unloaders



GENGUS
19-05-2006, 01:56 PM
Hi
Im new to the forum but already read and found some interesting stuff.

Im currently doing a full overhaul of the above compressor, simple enough until its gets to replacing the seals in the unloader assembly :eek: its a nightmare trying to get them together without damaging the new seals. As any member come across this problem and found a solution. Sabroe will build them up for a price:(

Andy
19-05-2006, 05:27 PM
Hi Gengus and welcome:)

The unloaders I am used to are in their big brother the SMC and are just a metal piston ring.

If I catch you right the seal in the unloader in a rubber type seal much like a hydralic cylinder.

In the past with these seals I have used a pipe reducer, and pushed the seal up this and unto the piston, cutting down the reducer to suit the OD that the seal has to go over.

Kind Regards. Andy:)

Lazarus
17-11-2006, 02:18 AM
Bit of oil
Vice
line them up and tighten
works every time