NGT
01-03-2017, 12:13 AM
Hi,
I moved into a house last year and it already had installed an aircon unit in 3 of the bedroom. The house was a repossession so no info on how to use and no remote control etc.
The 3 units are the same. The inside units are LG SO9AW (AS-W096RPH0) and the outside units are LG S12AW (AS-W126RPH0)
I purchased a universal remote and when I switched them on all 3 have the same issue. The units run for about a minute and then they shut down. The same happens if I select a heat or cool setting. The light on the front flashes 6 times. I understand this is has the following error code:-
"Indoor unit coil sensor fault. Disconnect from PCB measure resistance. 10 kOhm at 10C and 4 kOhm at 30C. if not replace sensor. Split = text 21"
Would anyone be able to confirm if this is the correct code? Not sure if this is an expensive fix where I may have to replace the boards etc, especially if I have to do it for the 3 units?
Any help much appreciated.
Nigel.
I moved into a house last year and it already had installed an aircon unit in 3 of the bedroom. The house was a repossession so no info on how to use and no remote control etc.
The 3 units are the same. The inside units are LG SO9AW (AS-W096RPH0) and the outside units are LG S12AW (AS-W126RPH0)
I purchased a universal remote and when I switched them on all 3 have the same issue. The units run for about a minute and then they shut down. The same happens if I select a heat or cool setting. The light on the front flashes 6 times. I understand this is has the following error code:-
"Indoor unit coil sensor fault. Disconnect from PCB measure resistance. 10 kOhm at 10C and 4 kOhm at 30C. if not replace sensor. Split = text 21"
Would anyone be able to confirm if this is the correct code? Not sure if this is an expensive fix where I may have to replace the boards etc, especially if I have to do it for the 3 units?
Any help much appreciated.
Nigel.