PDA

View Full Version : Daikin DX unit


eire1
23-01-2017, 07:34 PM
Hey guys, would you have a wiring diagram for two boards *I'm at a unit, a Hi-Velocity HV-100BU AHU indoor with a RZQ140B8W1B outdoor. Complaint it won't heat but I can't get the condenser to run. Only details I see are FBQ35-60B7V1 and an EC9509D. Any ideas? Calling for full heat but the condenser just sits there.
Brian_UK
23-01-2017, 08:02 PM
Has the RZQ unit had the software updated? B series had poor inverter/fan control.
frank
23-01-2017, 08:09 PM
Hey guys, would you have a wiring diagram for two boards *I'm at a unit, a Hi-Velocity HV-100BU AHU indoor with a RZQ140B8W1B outdoor. Complaint it won't heat but I can't get the condenser to run. Only details I see are FBQ35-60B7V1 and an EC9509D. Any ideas? Calling for full heat but the condenser just sits there.

I've installed and serviced/repaired lots of Daikin but can't understand your setup?

Hi-Velocity HV-100BU AHU...not familiar with this

with a RZQ140B8W1B outdoor...not sure how you can pair this with the AHU?

FBQ35-60B7V1 and an EC9509D...this doesn't make any sense?

Do you have different model numbers so far away from those in England?
eire1
23-01-2017, 09:49 PM
Doubt it, it was our 1st time on site today and the unit looks like it hasn't been serviced in a good good while.
eire1
23-01-2017, 09:53 PM
It's a Daikin condenser used as a heat pump to a coil on an AHU. The controllers are April Air, AHU is Hi-Velocity. It's the strangest set up I've ever seen. They're both wired into a panel with 2 Daikin boards. The 2 codes are the only info I can see on the boards.
Brian_UK
23-01-2017, 11:15 PM
I've seen these set ups before, condenser feeding the ahu coil using the pcb control board from a daikin unit, sort of worked.
frank
24-01-2017, 04:24 PM
That's the ERQ model condenser and AHU controller
al
24-01-2017, 11:30 PM
Its a board from a ducted unit i think, hi velocity units, bunch of them installed here, quare ****e. First check you have correct voltage at outdoor, and that neutral is properly connected. Indoor stat feeds to board to call outdoor, can you hook a standard daikin controller to the indoor board and test run unit?
frank
25-01-2017, 07:37 PM
Here's a link to the Daikin info http://www.daikin.co.uk/binaries/DEU-1615%20Daikin%20enhances%20its%20ventilation%20range%20for%20publication_tcm511-367499.docx
alicechan11
29-01-2017, 03:09 PM
Hey guys, would you SEO (http://www.seo-hkexpert.com/) have a wiring diagram for two boards *I'm at a unit, a Hi-Velocity HV-100BU AHU indoor with a RZQ140B8W1B outdoor. Complaint it won't heat but I can't get the condenser to run. Only details I see are FBQ35-60B7V1 and an EC9509D. Any ideas? Calling for full heat but the condenser just sits there.thanks for sharing