PDA

View Full Version : Parameters of SAnyo RCS-TM80BG



1jupilersvp
24-11-2016, 10:04 PM
Hello all,

I have a question regarding SANYO control panel and outdoor unit :

During normal operation for heating, the outdoor unit has 2 or 3 different 'speed' of compressor/fans.

Is it possible to force the outdoor unit to the low 'speed' ? Via a parameter set on the control panel ?

I measured the current of the outdoor unit, and I had a first step at 8A, after some minutes, it switch to 13A and then max measured at 18A.

For several reasons, I would like to limit the current at 8A.

Thanks for your help.

Manu.

Brian_UK
24-11-2016, 10:31 PM
You have quoted the reference model number of the remote controller, we need to know the model number for the indoor and mostly the outdoor unit.

1jupilersvp
24-11-2016, 11:02 PM
Hello, thanks of your reply.

The outdoor model is a Winverter 484 from Airpac (climastar). But It is a Sanyo 42,000 BTU with 2 fans.

Indoor unit is a specific unit from Airpac to use it as a Heating Pump Air/water. The indoor unit has a similar control card than indoor units for cooling.

Hope it can help you...

Thanks.