ambient
29-04-2016, 06:33 AM
Hey guys,
been asked to re-position and re- wire some controllers on 10 ducted Daikin VRV Heat recovery units ,as the builder will remove some walls and then will be new open floor layout in the office .
would like ask you guys about procedures.,I mean being Daikin hopefully won't be very difficult so,;?
1.Turn off power ind / out
2.re wire indoor units and controllers
3.turn on power ind/out
Also do I need to change to new group settings or will change automatically?
there is I Controller as well.
thanks
been asked to re-position and re- wire some controllers on 10 ducted Daikin VRV Heat recovery units ,as the builder will remove some walls and then will be new open floor layout in the office .
would like ask you guys about procedures.,I mean being Daikin hopefully won't be very difficult so,;?
1.Turn off power ind / out
2.re wire indoor units and controllers
3.turn on power ind/out
Also do I need to change to new group settings or will change automatically?
there is I Controller as well.
thanks