carrier vector 1800

[charlie patt]

Have a vector that says engineer reset required I'm sure if I remember correctly u could reset it on the panel can this be done or plug in job ta gents

[cadwaladr]

99 percent it's a plug in job Charlie,someone said you could do it thru the keypad which I doubt it's normally activated so drivers can only clear codes so many times to stop them screwing up an engine,I will ask my mate in oz for you.

[cadwaladr]

Hi Charlie,someone has said you maybe able to clear it without a pc,go into alarm mode then up and enter for 3to5 seconds

[charlie patt]

Cheers will try that ta

[cadwaladr]

Code 11and12 are low oil pressure and high water temp,if these are reset three times in a two hour period technician reset is triggered,oz friends say code 21 in the inactive alarm list needs to be cleared hope this helps buddy.