madcash2
19-02-2016, 06:22 AM
HELLO ALL
Can anyone advise me what is the best course of action to take. I have a thermoking sb iii unit with a X430 compressor. My issue is that the ball in the site glass is not going up despite the pressure on low side being about 40 psi and high side 300 psi. I tried to change the drier but there is not difference. The unit seems to be cooling but not at as fast as it should. Just not sure why the ball is either down or bouncing at the bottom.
Please advise what you think could cause it not to rise up. Oh by the way the temp at these pressures was between -1 to -2c.
Thanks
Can anyone advise me what is the best course of action to take. I have a thermoking sb iii unit with a X430 compressor. My issue is that the ball in the site glass is not going up despite the pressure on low side being about 40 psi and high side 300 psi. I tried to change the drier but there is not difference. The unit seems to be cooling but not at as fast as it should. Just not sure why the ball is either down or bouncing at the bottom.
Please advise what you think could cause it not to rise up. Oh by the way the temp at these pressures was between -1 to -2c.
Thanks