PDA

View Full Version : 2nd Hand Danfoss SMVE motor drive needed desperate. (S.West UK.)



Grizzly
28-10-2015, 07:31 AM
Hi Guys.
I am to attend a site this morning where their SMVE actuator motor,
(E = 4-20ma signal control) has shaken itself to bits literally!
A long story and I have not time to go there.
I know these have not been supported / available from Danfoss for a very long time.

It's a long shot, I know!

But has anyone got an old usable one hanging around?
The plant needs to be kept going for the next few months. When it is due to be scrapped.
But in the meantime unless I can resurrect the existing one they are dead in the water.

Thanks Grizzly.

RANGER1
28-10-2015, 10:47 AM
Grizzly not sure if this is helpful.

http://bosch.lektronix.net/equipment/83556/danfoss/other/smve+24/smve24/

Glenn Moore
28-10-2015, 05:40 PM
Hi Grizz
Got a couple of new ones in my garage
Plus a brand new MeV 125 valve complete plus MeV gland assemblies

Grizzly
28-10-2015, 10:52 PM
Bugger!
If only I had posted earlier!
I and the customer have gone down the route of ordering a ICV housing with a ICM module and ICAD Actuator.
Time is of their essence!
All the same where (Roughly) is your Garage? It may yet prove useful!
Incidentally the MEV is a 80-6.
Thanks for the input, nice one!
Grizzly

Grizzly
28-10-2015, 10:55 PM
Grizzly not sure if this is helpful.

http://bosch.lektronix.net/equipment/83556/danfoss/other/smve+24/smve24/

WOW! Now that is an interesting site, definitely one for Future use!
Thanks Ranger
Got to spread the love Sorry!
Grizzly

Glenn Moore
28-10-2015, 11:23 PM
Hi Grizz
I'm in sunny Dartford Kent on the M25 car park

Grizzly
28-10-2015, 11:37 PM
Hi Grizz
I'm in sunny Dartford Kent on the M25 car park
Hi Glenn
That used to be God's country when I worked for J&E Halls!
I won't be popping around for a cup of tea then.
Keep up the good work.
Grizzly